Close

Company News

Pressure Relief Valve

Pressure Relief Valve

Use and performance:

The release valve is mainly used to make the gas pressure in the container does not exceed the predetermined value, when the pressure is higher than the release pressure (P), the valve will automatically open, so that the gas leakage, when the pressure is lower than the release pressure (P), the valve will automatically close. In addition, the user can pull the ring at any time to open the valve to release internal pressure.

Main technical parameters:

1, Pressure Relief Valve range :P= 0.03mpa or P= 0.06mpa (can be customized according to user requirements)

2, mounting thread :G1/4-18(can be customized according to user requirements)

3, the use of ambient temperature :-35℃~80℃;

4, relative humidity :≤95%.

Use matters needing attention:

1. The Pressure Relief Valve is installed in the way of thread, and an appropriate amount of raw tape should be wrapped around the thread during installation

Ensure the sealing of thread;

2. The release valve should be installed in a position where the released gas will not contact the human body, especially the air temperature

When the degree is higher, attention should be paid to ensure safety;

3. When pulling the ring, pull it according to the arrow in the picture and keep the rod on the ring in the same position

Move all the way online, and release the pull ring slowly when reset; This release valve can not be used in rubber, copper corrosive occasions.


Categories

tips

Contact Us

Contact: Tianjin Delda Trading Co., Ltd

WhatsApp: +86 13022268465

Tel: +86 13022268465

E-mail: solomon20210701@tjxddq.com

Add: 55-302 Xiaoyuan New Village, Tianjin Economic and Technological Development Zone, China