An introduction of pressure release valve

Use matters needing attention:

1. The release valve is installed in the way of thread, and an appropriate amount of raw tape should be wrapped around the thread during installation

Ensure the sealing of thread;

2. The release valve should be installed in a position where the released gas will not contact the human body, especially the air temperature

When the degree is higher, attention should be paid to ensure safety;

3. When pulling the ring, pull it according to the arrow in the picture and keep the rod on the ring in the same position

Move all the way online, and release the pull ring slowly when reset; This release valve can not be used in rubber, copper corrosive occasions.